Please Note: This product does not come with a UK Cable. If required, please select PoE kit from the dropdown above. The Power Port can be used to power the airCube. This requires a 5V power adapter with a Micro-USB connector (not included). Please Note: The PSU included with this product is the EU version only. For UK use, please select the PoE Kit POE-24-24W-KIT from the ' Accessories, Add-Ons, and Extras' section above. Ubiquiti airCube airMAX AC Home Wi-Fi Access Point ACB-AC

Ubiquiti airCube ACB-AC airMAX Home Indoor WiFi 5 PoE Access

Then I did some speed tests. Sitting about 10 meters away from both Ubiquiti Unifi UAC-Pro (one of the enterprise access points) and AirCube, I got the following results. The innovative antenna provides wide-area coverage, and the airCube’s elegant design allows you to place it anywhere.Verify that the device has the correct default gateway/subnet if configured with a static IP. The gateway should be the airRouter IP in this example. For airCubes (ISP and AC): Push reset button and hold while powering unit.LED panel should blink fast several times, continue holding the reset button and the LED should turn off. Now you can release the reset button and the LED will flash slowly three times. If no DHCP server is present or an IP cannot be obtained via DHCP, the radio will revert to 192.168.1.20

Ubiquiti ISP Wireless - Guide to Configure Port Forwarding – Ubiquiti

The supplied power adapter is 24V and it can power another Ubiquiti 24V device through the PoE out port without having to connect a PoE adapter into PoE In port. Doesn’t seem like a big deal but PoE adapters cost money so this feature will save a little bit. Configure your computer: Windows PC's Ethernet must be configured manually with the following settings (under Network Connections): This Gigabit Ethernet port is available to connect a 10/100/1000 Mbps device to the internet. It also accepts 24V PoE input and can be used to power the airCube. Aircube can be configured as either AP or repeater. Every major configuration change results in having to restart the device. For this customer, AP is what I need as it will be connected to a wireless P2P link. Repeater is useful for situations where you want to connect to a router further away and place your own access point in the middle.Signal LEDs will keep blinking one by one in 4 different colors during firmware upgrade. Wait for about 7-10 minutes (devices and firmware depending). Remember to not power off the device during the procedure. By reloading fresh firmware to restore the device, this process can also be useful to recover devices that have appeared to fail when no other solution is working.