Colron Refined Jacobean dark oak Danish oil 0.5L.You can apply this danish oil from the Colron Refined range to using a cloth to colour and provide protection. It takes 6 hours to dry.

For a smooth, silky finish, lightly sand the danish oil between coats with very fine sandpaper or wire wool Apply the Danish Oil liberally with a clean, lint-free cloth or natural bristle brush, and wipe off any surplus oil after a few minutes

Colron Refined Danish Oil 500ml - Jacobean Dark Oak

The board was left at room temperature for 48 hours before it was used to allow the Danish oil to cure. The performance of Danish Oil will continue to improve naturally for a week or two after application. We recommend that wood should not be subject to heavy use, and any water or other spills should be wiped off immediately during this time. Our Danish Oil is based on Tung Oil, and is a penetrating oil which will ‘feed’ and protect wood. Varnished, shellaced, lacquered or heavily stained wood will usually present a surface barrier to absorption of the Danish Oil, and will need to be removed as necessary with a proprietary paint stripper.

Application during the second day was the same as the first. Danish Oil was applied until the wood stopped absorbing. After 20 minutes all excess oil was removed with a clean rag. Day three involved the same process again. By this time the wood was not absorbing much oil, and looked very ‘wet’ after oiling.After 20 minutes the excess oil was removed with a clean rag. Always do a small test area to confirm performance and compatibility before starting any project and follow the manufacturer's instructions on the container at all times.As with any coating, surface preparation is extremely important in getting a satisfactory end result. This method allows Danish Oil to be completely applied during the course of a single day, and the wood to be ready to use after 48 hours. Barrettine Danish Oil should be applied at a room temperature of between 15°C - 25°C Do not apply below 5°C. Stir / shake well before use. Any ‘nibs’ or dust on the surface of the wood during oiling cannot be removed with this method of application until the wood has been left to dry for at least 24 hours. The particles should then be removed with a very fine grade wire wool (oooo grade). Our first average we look at for Colron Refined Jacobean dark oak Danish oil 0.5L is to judge it against other products from the same brand, in this case it’s Colron. This tells us that there are a total of 53 Colron products at B & Q.

The photograph below was taken at a low angle to show the low sheen finish after application and finishing with Danish Oil. Finished This method is suitable when working on large areas, or when there is a limited amount of time available for oiling each day.

For a superior smooth danish oil finish, the final coat may be applied using a plastic scouring pad, rubbing in the direction of the grain and wiping away any surplus with a soft, lint-free cloth To ensure proper drying the temperature should be above 10 Degrees C and Danish Oil should not be applied in damp conditions. Do not apply in direct sunlight.

The key thing to consider here, is how the price of Colron Refined Jacobean dark oak Danish oil 0.5L compares to others but taking into account the quality and features of Colron Refined Jacobean dark oak Danish oil 0.5L over the other options.

A guide to online shopping

The idea of this method is to keep the wood surface’wet’ with Danish Oil for at least an hour until it has fully absorbed enough oil to provide a natural protective coating from deep within the wood.