However, I can't solely place a fix on that alone, because I also tweaked other settings at the behest of Corsair support. They are as follows: If so, the issue may be caused by the latest iCUE software update coming into conflict with your Windows build. You can try one of the following fixes below. I remembered that last time my scimitar mouse would not update its firmware, support had me do it in safe mode. I cue.hid_device_detector: Add close task: "\\\\?\\hid#vid_1b1c&pid_0a32&mi_03#8&28fe0412&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}"

ST100 RGB PREMIUM HEADSET STAND - CORSAIR ST100 RGB PREMIUM HEADSET STAND - CORSAIR

Disable USB Selective Suspend, located within the Advanced Power Options of the Windows Control PanelI cue.firmware.update.controller: "ST100RGB" FW update has been started. From "Primary FW: 0.02.91; Secondary FW: 0.02.91; Bootloader FW: 0.01" to "Secondary: Application: 0.4.106" Let’s take a closer look at the Corsair ST100 RGB Premium Gaming Headset Stand. Questions or comments? Hey guys so I spent a bit of time trying to resolve this issue and I have finally run out of options. Rebooted the PC, reinstalled using the latest Software Directly first, did not automatically run the software after install, went into the folder, ran it as admin.

ST100 Headphone Stand F/W Update - Corsair Community ST100 Headphone Stand F/W Update - Corsair Community

First off, and as a tech professional, there isn't anything wrong with your ST100 hardware-wise if it's connecting via USB and lighting up. I began noticing problems with mine immediately as well, and these problems could be fixed with the proper drivers and firmware if they ever cared to update it. I'm getting the same issue as everyone else where when trying to update the ST100 firmware it disconnects and fails. Can all of you confirm which version of iCUE and Windows you are on? Just to confirm, the primary issue you all are having is that ST100 is not showing in iCUE after performing the firmware update? Does not want to update to newest version/crashed and stays disconnected from iCUE until I re enter its USB Cable to my PC. Hower the newest patch seems to be not applied so it is still 0.02.91 and crashes again when trying to update via iCUE. :sigh!: The ST100, for whatever reason, seems to work best with only partial USB initialization, for me that meant going into the BIOS and enabling Fast Boot.Me too! I tried every USB port on my PC, and nothing works. Works fine for every other device in iCUE, except this. This product is problematic, and unfortunately...Corsair support just goes immediately to replacement rather than passing on our information to the experts. We'll just have to do the best we can here. I'm still having trouble with power issues though. It seems to be failing with code 1167 in the logs. It'll shut down and then continuously try to start up again but never make a good connection. Not that i am aware of. Most CUE related issues e.g. Device not detected, device disconnecting, effects not running are usually resolved when the device is plugged into a AMD/Intel controlled port rather than a third party one.